SHULIY GROUP

Email:info@bestshuliy.com

WhatsApp/Tel:+86 17319793602

  • Peanut processing machine manufacturer
  • peanut butter processing machine

Seven steps for using the peanut peeling machine

Post by adminAug-02,2018

The peanut peeling machine is an ideal device for removing peanuts, almonds and broad bean husk. Matching with fried peanuts production line can be used for production of large manufacturers. This machine can also be used for removing the outer skin of almond and faba bean. After modification, the outer skin of almond can be removed after replacement of some parts. Now let's introduce the steps of using peanut shelling machine:
Peanut shelling machine
First, before using the peanut peeling machine, we should first check whether the fasteners are tightened, whether the rotating parts are flexible, whether there are lubricating oil in each bearing, and whether the peeling machine is placed smoothly. In order to ensure the safety of the operator, but also to take the motor shell grounding protection (the motor shell with wire and grounding body reliable connection).
Two, turn the peanuts peeling machine into several circles before applying electricity. If there is a crash, the cause should be identified and electrified.
Three, suitable sieve should be selected according to the size of peanut kernel.
Four, after power on, we should try the operation first and pay attention to whether the steering of the rotor is correct. After the motor starts, the steering of the rotor should be consistent with the direction marked on the machine. The peanuts can be put into the hopper quantitatively, evenly and continuously after running smoothly.
Five, there is also a requirement for the dry and wet degree of peanuts, that is, peanuts must not be dry or wet. Too dry, peanut broken rate is high; too wet, shelling speed will slow down. The peanuts stored in the rural areas are generally dry in winter. In order to make it dry and wet, the following methods can be used as follows: sprinkled on 100 kg of peanuts with 15 kg of warm water and covered with plastic film for about 10 hours, and then dry off the shell for 1 hours in the sun. In other seasons, the use of plastic film covers only about 6 hours, and the rest of the operation methods are the same.
Six, the way to increase the peanut hull is to move the motor downward so as to tighten the fan belt and increase the blow volume.
Seven, when peeling, the peanut should be fed evenly and moderately. It is not allowed to be mixed with iron scraps, stones and other sundries to prevent breaking peanut kernel or causing mechanical accidents. When the peanut kernel is covered with sieves, the outlet switch can be opened.

Leave A Comment